Avago-technologies MegaRAID SAS 9240-4i User Manual download pdf (Page 8)

LSI Corporation

- 8 -

MegaRAID SAS Device Driver Installation User Guide

December 2012

Chapter 2: Windows Driver Installation

MegaRAID Primary Storage

Chapter 2: Windows Driver Installation

This chapter describes the installation of the following Microsoft® Windows® OSs:

 Windows XP (64-bit only)

 Windows 2003 SP2

 Windows 2003 R2 SP2

 Windows Vista SP2

 Windows 7 SP1

 Windows 8

 Windows 2008 SP2

 Windows 2008 R2 SP1

 Windows Server 2012

2.1 MegaRAID Primary Storage

In the MegaRAID primary storage configuration, the Windows OS is installed on virtual drives provided by the

MegaRAID controller. The MegaRAID controller includes a pre-boot configuration utility (WebBIOS) that creates the

virtual drive before the installation of the Windows OS starts.

To install the Windows OS, prepare a USB flash drive, CD-ROM or diskette, as appropriate, with the MegaRAID driver.

The driver is distributed in a series of nested compressed files. Using an existing Windows device, extract the files for

the driver-loading device (USB, CD-ROM, or diskette) by using the appropriate Windows driver. Only two driver

choices exist across the supported Windows versions: one for 32-bit systems or one for 64-bit systems.

2.1.1 Storage Configuration

These steps describe how to create the virtual drive used for the Windows OS. You can add other virtual drives to the

running OS after the Windows OS has been installed. The MegaRAID preboot BIOS utility (WebBIOS) that creates the

virtual disk for the Windows OS is accessible during the power-on self-test (POST) part of bootup.

Refer to the MegaRAID SAS Software User Guide for more information about the WebBIOS configuration utility (CU).

The following procedure describes the creation of a RAID 1 array. You can use other RAID levels, and the steps are the

same except when selecting the RAID level. In RAID 1, the RAID controller duplicates all data from one drive to a

second drive. RAID 1 provides complete data redundancy, but at the cost of doubling the required data storage

capacity. It is appropriate for small databases or any other environment that requires fault tolerance but

small capacity.

Follow these steps to create the virtual disk in WebBIOS:

1. When the host computer is booting, hold down the Ctrl key and press the H key when the following text appears

on the window:

Press <Ctrl><H> for WebBIOS

The Controller Selection window appears.

2. If the system has multiple SAS/SATA controllers, select a controller.

3. Click Start.

The main WebBIOS CU window appears.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 48 49

Comments to this Manuals

No comments

Avago-technologies MegaRAID SAS 9240-4i User Manual Page 8

Comments to this Manuals

Related products and manuals for Hardware Avago-technologies MegaRAID SAS 9240-4i